Wooden Walls

When wood floor is not enough

Wooden parquet can be laid not only on the floor but also on the walls. Generally, wooden interiors are favourites because of warm and earthy colours. If you want to have one exceptional room in your home, but are not sure how to do it, you will never go wrong with wooden floorboards as a wall decor element. Just have a look at the gallery below. Wood is a natural material, it will guarantee relaxation for your eyes and soul.

 

Installation Instruction

montuotojas1

STEP 1
Check the level of the wall using a spirit level. The deviation must not exceed 2 mm over 2 metres.

montuotojas2
STEP 2
Mark the places where the wooden construction floats, with a cross-section measuring at least 18mm x 50mm, are to be attached. Attach the first float a maximum of 10cm from the internal or external corner.

3

STEP 3
The distance between subsequent floats should not exceed 50 cm.

4

STEP 4
Attach the floats using rawlplugs, remembering that their heads must not protrude beyond the float.

5

STEP 5
The floats must form a single plane. Check this by using a spirit level applied over a width of at least 3 floats. If necessary use plywood or other material to level the structure.

6

STEP 6
Check the level of the wall using a spirit level. The deviation must not exceed 2 mm over 2 metres.

7

STEP 7
Before fitting the boards, acclimatise them in their factory packaging for around 48 hours. The Landero board is made from natural wood, which makes its pattern unique. Because of this, select and decide on the colour scheme of the surface to be covered before starting.

8

STEP 8
Apply wood or construction glue to the wooden structural beams (to a height of one board). Lay the first board, with the tongue removed, to the glued grid and fix it from above with the clips.

9
STEP 9
Fit the mounting clip into the protruding groove, then screw it on to each beam with the aid of a wood screw.

10

STEP 10
Connect the subsequent boards together using the locks, knocking them home.

11
STEP 11
The external corners can be finished by, for example, trimming the edges of the boards at an angle of 45 degrees. Apply assembly glue where the edges meet.

12
STEP 12
Apply assembly glue where the boards meet at the corner trimmed in this way.

13

STEP 13
Then glue in an aluminium flat bar, for example, at this point, which serves as both decoration and protection on the sharp trimmed edge. Aluminium or wooden angle bars can be used instead.

14

STEP 14
The end result. Many finishing elements can be used, such as shelves or hangers.